Filter
Top Products
Use and Care
Aluminum Filter
For highest efficiency, this filter should be removed and cleaned periodically.
Soak the filter in hot water and mild soap or detergent. Rinse thoroughly and
repeat if necessary. Heavy grease buildup may not be cleaned easily, thus the
filter may need to be replaced.
Hint: It is recommended to clean the aluminum filter ever time the filter change
signal is activated.
HEPA/Charcoal Filter
This filter should be changed when the filter change signal is activated. This filter
cannot be cleaned and must be replaced when it becomes saturated. Contact
Haier at 1-877-337-3639 or check with your local retailer or dealer to purchase
replacement filters. Please note that if power is lost on 3000 series, the filter
change signal timer also resets. If this happens, you may need to replace the
filter before the change signal is activated. See prior section for instructions on
how to the reset the filter change signal for your specific model.
Light Bulbs
The 4000 series model specifies an 8W-PAR20 LED, but halogen or incandescent
bulbs that meet specifications can be used on all models.
Exterior Surface
Wipe the range hood exterior with a soft cloth and a mild detergent suitable for
painted surfaces. Do NOT use abrasive materials such as steel wool pads or
scouring powders.
Repair or Replacement Parts
Warning! Disconnect range hood from the electrical power supply before
servicing.
All parts may be obtained from service centers authorized by Haier, or may be
ordered directly from Haier. When ordering parts, please specify the range hood
model number on the rating label, which is located on the inside of the range
hood.
15
English