Filter
Top Products
English
11
1. Hang hood from (4) Mounting Screws (from parts bag). Be sure to place
a washer (included) onto each screw before driving in the screw. Slide
hood towards wall until mounting screws are engaged in narrow end of (4)
Keyholes. Tighten mounting screws securely.
2. Replace bottom cover.
3. Connect ductwork to hood. Use Duct Tape to make joints secure and air tight.
4. If you have a 4000 series model, install (2) dimmable PAR 20, 8W LED lights.
Please note that the LED lights must be dimmable in order to adjust light settings.
If you have a 3000 series model, install (2) PAR 20, 50W halogen lights.
CAUTION: Bulbs may be hot! Refer to bulb packaging for further information.
5. Replace filters*, turn on power at service panel, and test range hood for
proper operation.
* If hood is to be installed Non-Ducted, install either the HEPA or charcoal
filters (whichever are included with your model) in place of the aluminum
filters that were removed earlier. The HEPA or charcoal filters can be
found in a plastic bag labeled as such included with your unit. For Ducted
installations, reinstall the aluminum filters.
Installing Hood
GREEN
GROUND
SCREW
DUCT
TAPE
PAR20, 50W MAX. HALOGEN BULB
(2) -or- PAR20, 8W MAX. LED BULB
KEYHOLE
(4)
MOUNTING
SCREW
(4)
!
GREEN
GROUND
SCREW
DUCT
TAPE
PAR20, 50W MAX. HALOGEN BULB
(2) -or- PAR20, 8W MAX. LED BULB
KEYHOLE
(4)
MOUNTING
SCREW
(4)
!
GREEN
GROUND
SCREW
DUCT
TAPE
KEYHOLE
(4)
MOUNTING
SCREW
(4)
!