Filter
Top Products
5 6
Freezer Installation
1) The freezer is designed for free-
standing installation only.
2) Install the freezer on a base
strong enough to support it when
fully loaded. Ensure the freezer is
on a stable surface to minimize
noise and vibration.
3) When moving the freezer, never
tilt at an angle more that 45 as
this cou ld dam age the
compressor and freezer system. If
the freezer is tilted over 45 , or has
been stored on its side, allow the
freezer to stand upright for at least
24' hours prior to plugging it back
in, this will allow the refrigerant to
settle.
4) Install the freezer in a well-
ventilated area away from any
heat source or direct sunlight. Air
must be allowed to circulate freely
around the freezer. Allow at least 3
inches (7.5 cm) of clearance
space for the top, back and sides.
5) Install the freezer in a dry place
to prevent rust from forming on
the compartment body and to
avoid the risk of damaging the
electric insulation.
1) IMPORTANT: For personal safety,
this appliance must be properly
earthed.
2) The rated voltage for this
appliance is 220V to 240V. In the
event that your regional power
supplier connot meet this
requirement, please use a safe
and reliable automatic voltage
regulator with a minimum output of
500W to avoid damaging the
compressor.
E le ct r ic Co nn ec ti on a nd
Precautions
Electric Control Panel
The main functions of the electronic
control panel are:
1) The control panel is numbered
1,2,3,4,5,6,7. This refers to the
temperature on the inside of
the freezer. The temperature is
lowered by turning the dial in
clockwise direction.
When dial is near the "1"
position, the interior average
te mp er atu re of fre ez er is
approximately 10 C ~ -2 C.
When dial is near the "2-7"
position, the interior average
te mp er atu re of fre ez er is
approximately -2 C~ -26 C.
When you change the dial from
refrigerate function to freeze function,
the food in the freezer should be taken
out to avoid freeze.
2) The green lamp indicates that
the appliance is connected to a
power supply. The green lamp
illuminates when the freezer is
connected to an appropriate
power supply.
3) The yellow lamp illuminates
when the "Quick Freeze"
function is working. Quick
freezing can retain the original taste
of the food.
4) All control equipment is
installed on the control panel
situated on the exterior of the
freezer.
Refrigerate:
Freeze:
-1
-2
-3
-4