Haier ECR1 7 Refrigerator User Manual


  Open as PDF
of 38
 
Unpacking Your Refrigerator
1. Remove all packaging material. This includes the foam base and all adhesive
tape holding the refrigerator accessories inside and outside.
2. Inspect and remove any remains of packing, tape or printed materials before
powering on the refrigerator.
Leveling Your Refrigerator
t:PVSSFGSJHFSBUPSIBTUXPMFWFMJOHMFHTXIJDIBSFMPDBUFEJOUIFGSPOUCPUUPN
corners of your refrigerator. After properly placing your
refrigerator in its final position, you can level your refrigerator.
t-FWFMJOHMFHTDBOCFBEKVTUFECZUVSOJOHUIFNDMPDLXJTFUPSBJTFZPVS
refrigerator or by turning them counterclockwise to lower your refrigerator. The
refrigerator door will close easier when the leveling legs are extended.
Proper Air Circulation
t5PFOTVSFZPVSSFGSJHFSBUPSXPSLTBUUIFNBYJNVNFGGJDJFODZJUXBTEFTJHOFE
for, you should install it in a location where there is proper air circulation,
plumbing and electrical connections.
t5IFGPMMPXJOHBSFSFDPNNFOEFEDMFBSBODFTBSPVOEUIFSFGSJHFSBUPS
Sides…………….4 " (100mm)
Top....................4" (100mm)
Back..................4" (100mm)
Door Alignment
1. Remove the top hinge cover by using a flathead
screwdriver. Place the head under the front edge
of the cap and gently lift.
2. Loosen the top hinge screws using a Phillips
head screw driver.
"EKVTUUIFEPPSPSQVUBTQBDFSJOCFUXFFOBOE
tighten the screws.
4. Replace the top hinge cover by aligning the rear
of the cover with the rear of the hinge. Press
firmly on the front of the
cover until it snaps in
place.
5
English
INSTALLING YOUR REFRIGERATOR
fig. 1
 previous next