Filter
Top Products
Installation
1. Remove the packaging and take out the distance limiter from accessory in
microwave oven (some models have been installed already), unlock the power
cord, according to the specific shape of distance limiter, install by following the
given instruction. The purpose of the distance limiter is to make the microwave
oven to keep a certain distance from the wall.
2. Take out all the packing. Carefully check whether there is damage to the
microwave oven. Such as:
a. the oven cavity is impacted or pressured.
b. the door is not flat; the switch is not smooth and flexible.
c. the metal Insulated mesh on the door is bended or deformed.
d. the power cord is loose.
IF IT IS FOUND ABOVE, CONTACT YOUR NEAREST SERVICE CENTER APPROVED.
3. Microwave ovens must be placed under dry and non-corrosiveness environments,
kept away from heat and humidity, such as gas burner or water tank.
4. To ensure sufficient ventilation, the distance of the back of microwave to the wall
should be at least 10 cm, the side to the wall should be at least 5 cm, the free
distance above the top surface at least 20 cm.
5. The position of the oven shall be far from the TV, Radio or antenna to avoid
disturbance, the distance at least more than 5 m.
6. The appliance must be positioned so that the plug is accessible, and must ensure
a good grounding in case leakage, ground loop can be formed to avoid electric
shock.
7. The microwave oven shall not be placed in a cabinet.
8. The back of the oven must be placed against a wall.
9. As there is manufacturing residue or oil remained on the oven cavity or heat
element, it usually would smell the odor, even a slight smoke, It is normal case and
would not occur after several times use, keep the door or window open to ensure
good ven
tilation. So it is strongly recommended to set the oven to grill mode and
operate dry several times. Operating dry can only be conducted in the grill mode, it
can not be conducted at combination mode.
10. To keep the microwave oven at a distance from the wall, it is necessary to install
a distance limiter
1