Filter
Top Products
Positioning th e Ap pl i an ce
Position the appliance in the desired location. The back should
rest against the wall behind it, and the sides, along the adjacent
cabinets or wall. The dishwasher is equipped with water supply
and drain hoses that can be positioned to the right or the left to
allow correct installation.
Levelling the Appliance
Once the appliance is positioned, adjust the feet (screw them in
or out) to level the dishwasher. The appliance should not be
inclined more than 2 degrees to ensure proper performance.
Cold Water Connection
Connect the cold water supply hose to a threaded 3/4 (gas) con-
nector and make sure that it is fastened tightly (see Fig 1).
If the water pipes are new or have not been used for an
extended period of time, let the water run first, till it is clear and
free of impurities. Otherwise the water inlet filter may get blocked.
Hot Water Connection
The appliance can also be connected to the house's hot water
supply following the same procedure as for cold connection.
This will reduce the wash cycle by about 15 minutes and the
wash efficiency will be slightly reduced.
DO NOT CONNECT TO A PUSH THROUGH HOT WATER
SYSTEM OR ONE THAT EXCEEDS A TEMPERATURE OF
60
° C.
Anti-Flooding Protection
The dishwasher will retain any leaks within the unit, in order to
prevent damage to your home.
Drain Hose Connection
Insert the drain hose into a drain pipe with a minimum diameter of
40mm, or let it run into the sink, ensuring there are no tight bends
or kinks. Use the plastic support (A) that comes with the appliance
(see Fig.2). The free end of the hose must be at a height between
40 and 100 cm and must not be immersed in water.
Attention:
The plastic hose support must be fastened to the wall to prevent the
drain hose from moving.
Electrical Connection
After making sure that the voltage and frequency values in the home
correspond to those on the rating plate (located on the stainless
steel inner door of the appliance) and that the electrical system is
sized for the maximum voltage on the rating plate, insert the plug
into an earthed electrical socket.
DO NOT USE ADAPTORS OR EXTENSION LEADS
.9.
Installation