Filter
Top Products
NOTE: Both of TIME DEFROST and
AUTO DEFROST can be set as the
first stage. Convenience Cooking
pads(i.e.Popcorn) cannot be used for
multi-stage cooking.
TIME DEFROST
1. Touch the TIME DEFROST pad, the
display will show dEF2.
2. Enter desired defrosting time with
the number pad.
NOTE: The default power setting for
defrosting is 30% (PL3), to change the
power level touch POWER once to
display the current power "PL 3", then
press the number pad of the power
level you wanted.
3. Touch START/+30 Sec to begin
defrosting.
AUTO DEFROST
1. Touch the AUTO DEFROST pad, the
display will show dEF1.
2. Enter weight to be defrosted in
ounces (oz.) with the number pad,
from 4 to 100 oz.
3. Touch START/+30 Sec to begin
defrosting.
• After setting AUTO DEFROST,
the oven can be programmed to
automatically switch to multiple-stage
cooking, follow the steps in the
multi-stage cooking section.
• During defrosting, you need to turn
food over for uniform defrosting. After
turning, touch START/+30 Sec pad to
resume defrosting.
SETTING CHILD LOCK
The safety lock prevents unsupervised
operation by children. Set the function
in standby mode.
To set: Press and hold STOP/CLEAR for
3 seconds. Lock icon is indicated on the
display and there will be a long beep.
To cancel: Press and hold STOP/CLEAR
for 3 seconds, there will be a long beep.
Lock icon disappears from the display.
MEMORY
You can store up to 5 programs into
memory for future use:
Touch the MEMORY pad, the number
1 will be displayed*. Set a 1 or 2 step
cooking procedure as described above.
Press MEMORY to save the setting.
To use a stored program, Touch the
MEMORY pad, the number 1 will be
displayed. Touch the START/+30 Sec
pad.
*Touch MEMORY repeatedly to access
memory locations 2 through 5.
PRE-SET COOKING
1. Program the clock if it has not been
programmed.
2. Set a 1 or 2 step cooking procedure
as described above.
3. Touch the CLOCK pad, the hour figure
on the clock will flash
4. Enter the time desired for the
program to begin (example 3:15 is
entered as 0315, 11:30 is entered as
1130)
5. Set AM or PM with the AM/PM pad
6. Touch the START/+30 Sec pad
7. The procedure will begin at the set
time.
PAGE 13 • SET UP & USE
ENGLISH
OPERATION INSTRUCTIONS CONT.