Filter
Top Products
Defrosting
The surface of evaporator ices up when
the refrigerator is working. When the frost
layer is thick as 3mm, the refrigerator must
be defrosted and cleaned. Otherwise, it
may results in lower efficiency and high
energy consumption.
1. Take out foods and ice tray. Keep the
door open.
2. Set the temperature at ‘0’ position.
After defrosting, dry the water tray and
then replace it in the refrigerator. Reset
the temperature regulator to its original
position.
Note: Never use a sharp or pointed item
to defrost or loose the ice tray. Otherwise
it’s likely to damage the surfaces of the
evaporator and result in the leakage of
refrigerant. The manufacturer takes no
responsibility for cost of the reparation
even the appliance is under guarantee.
.7.
Defrosting/Cleaning
Making ice
Fill the 3/4 ice tray with water and then
place it in the lower part of the evaporator.
Set the temperature regulator at ‘7’.
After making ice, reset the temperature
regulator to its original position. Otherwise
foods may get frozen.
To take out the ice cubes
1. Knock the ice tray lightly to loose it.
2. Hold the bottom of the ice tray in warm
water for a while.
3. Twist the ice tray to loose the ice cubes.
Lamp and lamp replacement
Lamp: 240V,15W
Lamp holder: E14 (lamps exceeding 15W
must not be used)
When replacing the lamp:
* Unplug to disconnect the power and
remove the water tray.
* Press the positioning pin of the lamp
with left hand, and release the shade
from the lamp holder by sliding it to the
right side. Turn the lamp anti-clockwise
for removing.
* Replace the water tray.