Filter
Top Products
9
English
CLEANING AND MAINTENANCE
Warning:
• To avoid electric shock always unplug your wine cellar before cleaing.
Ignoring this warning may result in death or injury.
Caution: • Before using cleaning products, always read and follow manufacturer’s
instructions and warnings to avoid personal injury or product damage.
General: • Prepare a cleaning solution of 3-4 tablespoons of baking soda mixed with
warm water. Use sponge or soft cloth, dampened with the cleaning solution,
to wipe down your wine cellar.
• Rinse with clean warm water and dry with a soft cloth.
• Do not use harsh chemicals, abrasives, ammonia, chlorine bleach,
concentrated detergents, solvents or metal scouring pads. SOME of these
chemicals may dissolve, damage and/or discolor your wine cellar.
Door Gaskets: • Clean door gaskets every three months according to general instructions.
Gaskets must be kept clean and pliable to assure a proper seal.
• Petroleum jelly applied lightly on the hinge side of gaskets will keep the
gasket pliable and assure a good seal.
POWER INTERRUPTIONS
• Occasionally there may be power interruptions due to thunderstorms or other causes. Remove the
power cord from AC outlet when a power outage occurs. When power has been restored, replug
power cord to AC outlet.
VACATION AND MOVING CARE
• For long vacations or absences, unplug the wine cellar and clean the wine cellar and door gaskets
according to "General cleaning" section. Prop doors open, so air can circulate inside. When moving
always move the wine cellar vertically. Do not move with the unit lying down. Possible damage to
the sealed system could occur
.
PROPER WINE CELLAR CARE AND CLEANING
REPLACING LIGHT BULB
1
. Turn off and unplug the power cord of the wine cellar.
2. To remove the light bulb cover use a philliphead screw driver to remove the 2 screws.
3. Make sure the light bulb is cool before removing it. Replace using a 10 watts light bulb.
4. After the bulb is secure, install the light bulb cover and replace both the screws.
5. Turn unit on to its original setting after plugging in the power cord.