Electrical Requirement
• Make sure there is a suitable power Outlet (115 volts, 15 amps
outlet) with proper grounding to power the wine & beverage center.
• Avoid the use of three plug adapters or cutting off the third grounding
in order to accommodate a two plug outlet. This is a dangerous
practice since it provides no effective grounding for the wine &
beverage center and may result in shock hazard.
Installation Limitations
• Do not install your wine & beverage center in any location not
properly insulated or heated, e.g. garage etc. Your wine &
beverage center was not designed to operate in temperature settings
below 55˚ Fahrenheit.
• Select a suitable location for the wine & beverage center on a hard
even surface away from direct sunlight or heat source, e.g. radiators,
baseboard heaters, cooking appliances etc. Any floor unevenness
should be corrected with the leveling legs located on the front and
rear bottom corners of the wine cellar.
• Your wine & beverage center is designed for freestanding installation
only. It is not designed for built-in application.
Use of Extension Cord
• Avoid the use of an extension cord because of potential safety
hazards under certain conditions. If it is necessary to use an extension
cord, use only a 3-wire extension cord that has a 3-blade grounding
plug and a 3-slot outlet that will accept the plug. The marked rating of
the extension cord must be equal to or greater than the electrical
rating of the appliance.
6
English
English