Filter
Top Products
Turning on the Appliance
Starting a wash cycle
- Make sure that the plug of the appliance is inserted into the wall
socket.
- Make sure that the water supply is turned on to full pressure.
- Load the dishwasher (see the section "Loading the
Dishwasher").
- Pour in the detergent (see the section "Salt, Detergent and Rinse
Aid").
- Turn the knob located on the right of the control panel clock
wise to the desired cycle number or symbol (see the section
"Wash Cycle Table").
- Press the ON-OFF button; the ON-OFF light will turn on. At this
point, the wash cycle will begin.
If you forget to load some of dishes
The wash cycle can be interrupted by pressing the ON-OFF
button. You can then load additional dishes and turn the appli-
ance back on. The appliance will resume operation from where it
was interrupted.
At the end of the wash cycle
When the knob stops turning and is aligned with the STOP mark
(see figure), the cycle has finished. Turn off the appliance using
the ON-OFF button, turn off the water supply and open the door
of the dishwasher.
Wait a few minutes before unloading the dishwasher to avoid
handling the dishes and utensils while they are still hot and more
susceptible to breakage. They will also dry better.
Cancelling or modifying a wash cycle setting
Premise: A cycle that is underway can only be modified if it
has been running for a short time. Otherwise, the detergent
may have already been used, and the appliance may have
already drained the wash water. If this is the case, the deter-
gent dispenser must be refilled (see paragraph "Loading the
detergent").
Press the ON-OFF button and the ON Light will turn off. Rotate
the knob clockwise to the desired cycle setting (see the section
"Starting a wash cycle"). Then, turn the dishwasher back on us-
ing the ON-OFF button.
.6.
GB