2
IMPORTANT SAFEGUARDS
1. Read all instructions.
2. Do not touch hot surfaces. Use handles or knobs. Care must
be taken, as burns can occur from touching hot parts or from
spilled, hot liquid.
3. To protect against electric shock, do not place cord, plug, or
BrewStation
®
in water or other liquid.
4. Close supervision is necessary when any appliance is used by
or near children.
5. Unplug from outlet when either the BrewStation
®
or clock is
not in use and before cleaning. Allow to cool before putting
on or taking off parts and before cleaning the appliance.
6. Scalding may occur if the lid is lifted during the brewing cycle.
Do not open lid until coffeemaker has cooled completely.
7. BrewStation
®
must be operated on a flat surface away from
the edge of counter to prevent accidental tipping.
8. Do not operate any appliance with a damaged cord or plug, or
after the appliance malfunctions or is dropped or damaged in
any manner. Call our toll-free customer service number for
information on examination, repair, or adjustment.
9. The use of accessory attachments not recommended by the
appliance manufacturer may cause injuries.
10. Do not use outdoors.
11. Do not let cord hang over edge of table or counter or touch
hot surfaces, including stove.
12. The coffee tank is designed for use with this BrewStation
®
. It
must never be used on a range top or in a microwave oven.
13. Do not place BrewStation
®
on or near a hot gas or electric
burner or in a heated oven.
14. To disconnect BrewStation
®
, turn controls to OFF, then remove
plug from wall outlet.
15. WARNING! To reduce the risk of fire or electric shock,
do not remove the bottom cover. No user-serviceable parts
are inside. Repair should be done by authorized service
personnel only.
16. Do not use appliance for other than intended use.
When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and/or
injury to persons, including the following:
SAVE THESE INSTRUCTIONS!
840177100 ENnv11.qxd:Layout 1 10/28/08 2:45 PM Page 2