Filter
Top Products
6
1. Unplug blender from electrical outlet.
2. Wipe blender base and cord with a
damp cloth or sponge. To remove
stubborn spots, use a mild, non-
abrasive cleanser.
3. To clean jar, unscrew cutting
assembly from jar.
4. Carefully remove gasket from
cutting assembly.
5. Remove dispenser assembly from jar
by turning
counterclock-
wise four
revolutions.
NOTE: DO NOT remove seal rings
from dispenser adaptor.
6. Carefully wash cutting assembly,
gasket, jar, and lid in hot, soapy
water. Rinse and dry thoroughly.
Do not soak. Do not wash cutting
assembly or gasket in a dishwasher.
NOTE: All parts except the cutting
assembly and gasket may be
washed in the dishwasher (on the
top rack only). Some part distortion
may occur if your household dish-
washer temperature is higher than
normal or if the parts are placed too
close to the heating element.
7. Reassemble cutting assembly and
gasket onto jar, and replace jar onto
blender base. Ensure dispenser
assembly or spout cap are fully
rotated clockwise to lock into posi-
tion (reverse of Step 5 above).
8. Store blender with lid or filler cap
removed to prevent container odor.
How to Clean
Quick cleaning should only be used to
rinse the blender between batches of
processing the same food. When the
processing of a single type of food is
finished, the blender should be disas-
sembled and thoroughly cleaned as
instructed below.
To quick clean, pour 2 cups (500 ml)
warm water in jar and add 1 drop liquid
dishwashing detergent. Run the blender
on
DISPENSE
for 10 seconds. Flush
soapy water through dispenser until
cleaned. Discard soapy water. Rinse
blender jar with clean water. Flush clean
water through dispenser until cleaned.
This function is not a substitute for
regular cleaning as instructed below
This function should never be used
when blending any mixture containing
eggs, milk, or any other dairy products.
Quick Cleaning
Regular Cleaning
Electrical Shock Hazard.
Disconnect power before cleaning.
Do not immerse cord, plug or base in any liquid.
w WARNING
840155501 ENv01.qxd 2/26/08 1:43 PM Page 6