Filter
Top Products
3
1. Read all instructions.
2. Blades are sharp; handle carefully.
3. Do not use a broken, chipped, or cracked blender jar.
4. Do not use broken, cracked, or loose blades.
5. Never place cutting unit blades on base without jar properly
attached.
6. Screw on jar nut firmly. Injury can result if moving blades acci-
dentally become exposed.
7. If jar should turn when motor is turned on, turn off immediately
and tighten jar in threaded jar nut.
8. Do not blend hot foods or liquids in the jars. Pressure will build
up in the jars and hot liquid will spurt out when opened.
9. Observe the MAX fill line. Do not fill jar above this line.
10. Do not store jars with cutting assembly in place. Remove cutting
assembly and wash after each use.
IMPORTANT SAFEGUARDS
SAVE THESE INSTRUCTIONS!
How to Use
IMPORTANT: Your Hamilton Beach Stay or Go
™
Personal Blending Jar
and cutting blades are subject to wear during normal use. Always inspect
jar for nicks, chips, or cracks. Always inspect cutting blades for broken,
cracked, or loose blades. Do not use damaged jar or cutting blades.
Call our toll-free customer service number to obtain replacement parts.
1. Make sure blender is unplugged. Place blender
base on clean, dry surface to keep foreign
particles from being pulled up into motor
during operation.
2. Place ingredients in personal blending jar.
Do not exceed MAX Fill Line. (Illus. 1)
3. Place cutting blades in jar nut. Fit gasket over
blades. (Illus. 2)
4. Set cutting assembly on top of jar and screw
on jar nut. Make sure the jar nut is firmly
screwed onto the jar. If not, it may loosen later
when motor is turned on. (Illus. 3)
5. Set personal blending jar in place on blender
base, making sure it is securely seated. Plug
cord into outlet. Follow the instructions provided
with your blender for operation. (Illus. 4)
NOTE: ALWAYS turn blender off and wait until
blades have stopped rotating before removing
jar.
6. Remove personal blending jar from base
after blending by lifting straight up.
NOTE: NEVER replace jar onto unit while
motor is running.
7. Invert personal blending jar so that the cutting
assembly is on top of the jar. Unscrew cutting
assembly then remove the jar nut, cutting
blades and gasket.
8. Screw lid on jar. (Illus. 5)
(Illus. 1)
(Illus. 2)
(Illus. 3)
(Illus. 4)
(Illus. 5)
2
840141000 v06.qxd 9/26/05 1:57 PM Page 2