Hamilton Beach 840210002 ENv01.indd 4 Blender User Manual


 
2
IMPORTANT SAFEGUARDS
1. Read all instructions.
2. To protect against risk of electrical shock, do not put cord,
plug, base, or motor in water or other liquid.
3. Close supervision is necessary when any appliance is used
by or near children.
4. Unplug cord from outlet when not in use, before putting
on or taking off parts, and before cleaning.
5. Flashing light indicates ready to operate. Avoid any contact
with blades or moveable parts.
6. Do not operate any appliance with a damaged cord or
plug, or after the appliance malfunctions, or is dropped
or damaged in any manner. Call our toll-free customer
service number for information on examination, repair,
or electrical or mechanical adjustment.
7. The use of attachments, including canning jars, not
recommended or sold by the appliance manufacturer
may cause a risk of injury to persons.
8. Do not use outdoors.
9. Do not let cord hang over edge of table or counter or touch
hot surfaces, including stove.
10. Keep hands and utensils out of jar while blending to reduce
the risk of severe personal injury and/or damage to blender.
A rubber spatula may be used but must be used only when
blender is not running.
11. Blades are sharp; handle carefully—especially when
assembling, disassembling, or cleaning inside blender jar.
12. Do not use a broken, chipped, or cracked blender jar.
13. Do not use broken, cracked, or loose cutting blade assembly.
14. To reduce the risk of injury, never place cutting blade assembly
on base without jar properly attached.
15. Always operate blender with lid in place.
16. When blending hot liquids, open vent opening of lid, and close
any lid openings intended for pouring. If pouring with lid in
place, ensure the hinged cap is securely in place. Hot liquids
may push lid off jar during blending. To prevent possible
burns: Do not fill blender jar beyond the 3-cup (750-ml) level.
With the protection of an oven mitt or thick towel, place one
hand on top of lid. Keep exposed skin away from lid. Start
blending at lowest speed.
17. Ensure collar on base of blender jar is tight and secure. Injury
can result if moving blades accidentally become exposed.
18. If the jar should twist or rotate when the motor is switched
ON (I), switch OFF (O) immediately and tighten jar in collar
or on blender base.
19. Do not leave blender unattended while it is operating.
20. To disconnect cord, turn the control to OFF (O). Then remove
plug from wall outlet.
21. Do not use appliance for other than intended purpose.
When using electrical appliances, basic safety precautions should always be followed, including the following:
SAVE THESE INSTRUCTIONS!
840210002 ENv01.indd 2840210002 ENv01.indd 2 3/8/13 10:55 AM3/8/13 10:55 AM