Filter
Top Products
Preparation
Setting up the Unit
The Ice Shaver/Blender must be placed on a
sturdy, level surface. It is recommended that it be
located near a sink or other drain location.
Leveling the Unit
For proper operation and drainage, the unit must be
level. Loosen the jam nuts and turn the leveling feet
(clockwise to lower a corner, counterclockwise to
raise a corner) until the unit is level and all four
leveling feet are in solid contact with the countertop.
Once the unit is level, tighten the jam nuts to lock
the feet at the desired height.
Drain Hose
The end of the drain hose should drain into a sink,
drain, or bucket. To ensure proper drainage, the
outlet end of the drain hose must be lower than the
fitting end, and there should be no kinks or pinch
points in the hose. If a tight bend is needed, such
as at the edge of a countertop, use an elbow fitting
and hose clamps (not included) to make the bend.
Preparing for Use
Before plugging in the unit for the first time, the ice
hopper should be sanitized. To do so:
1. Remove the ice hopper lid and lift out the inner
hopper.
2. Loosen the thumbscrew on the agitator assembly
and lift the assembly up and out of the ice pool.
WARNING: Shaver blade is sharp!
3. Remove the ice chute by pressing the release
button and pulling down on the ice chute.
4. Wipe the inside of the ice pool with a clean soft
cloth dampened with sanitizing solution (see
Cleaning Instructions for recommended sanitizing
solution).
5. Rinse the ice chute, the agitator assembly and
inner hopper in sanitizing solution, and allow to
air dry.
6. Once all parts are dry, slide the agitator assembly
carefully back into place and secure with the
thumbscrew. Align the bosses on inner hopper
with the matching holes in the ice hopper,
making sure that the interlock post is inserted
into the hole behind the inner hopper fin. Press
gently down into place. Reinstall the ice chute
by sliding it back until it clicks into place (press
the button slightly to allow the chute to slide over
the button).
7. Plug the unit into a grounded outlet.
8. Wash and sanitize the blender jar as described
in the section “Cleaning Instructions–Blender”.
Leveling
Feet
5
Jam
Nut
Drain
Hose
Fitting
Alignment
Bosses
Release
Button
Thumbscrew
Agitator
Ice Pool
Shaver
Blade
Inner
Hopper
Fin
Interlock
Post