Filter
Top Products
5
Hints for Best Use
• The can opener will easily open all standard size cans.
• On some models it will be necessary to position can opener
at edge of counter, allowing for clearance to open cans
taller than the can opener.
• If there is a bump, dent, or heavy seam in the rim of the
can, open the other end of the can or start cutter just
beyond the problem area.
• The motor of your can opener is permanently lubricated
and will require no oiling.
• To use the cord storage on the back of the opener, push in
or pull out the cord as needed.
Sharpening Knives
1. Place cutting edge of knife in the
knife slot located on the back of
the can opener. See Figure 4.
2. Draw the knife blade through the
slot several times.
NOTE: Serrated blades should never
be inserted into this unit.
4
How to Use Your Can Opener
This is new technology – does not need a magnetic arm.
1. Place can opener on level surface.
2. Plug cord into electrical outlet.
3. ON/OFF Switch must be in OFF position. See Figure 1.
Place rim of can up and under lid opener. See Figure 2.
OFF
position
4. Hold can and push Switch down.
See Figure 3. Can will be held in
place as long as switch is down.
5. Hold Switch down until can
makes one (1) full rotation totally
separating lid from can. Lid may
spin in reverse when completely
severed.
NOTE: Do not allow can to keep
rotating as the can opener may
continue to cut the can.
6. Release Switch and push back to OFF position.
Figure 1
Figure 2
Figure 3
Lid
Opener
Figure 4
7. To remove can, push down on lid and tilt can top toward can
opener. Pull can down and away from cutting wheel.
8. Remove lid from top of can and check can contents to
remove any pieces of label or metal shavings.
840082700 ENv01.qxd 2/20/01 10:02 AM Page 4