Filter
Top Products
Hearth & Home Technologies • BE-36-C, BE-36-CIPI • 397-981 Rev. V 1/0742
Log Set Assembly: LOGS-BE-36-CD. Positioning the Logs
If the gas logs have been factory installed they should not
need to be positioned. If the logs have been packaged
separately, refer to the following instructions.
Models: BE-36-C
Carefully remove the logs from the packaging. CAUTION: Logs are fragile!
397-935B 6/04
LOG #1 (SRV397-701): Place log #1 so the notch
on the right side rests on the right grate tine. The left side
of log #1 should rest on the pilot bracket. Slide the log to
the rear until it touches the rear tab.
LOG # 2 (SRV397-702): Place log #2 on the left
side of the grate in front of log #1. The left edge of log #2
should touch the fi rebox. The right edge of log #2 should
be pushed back until it touches the tab. NOTE: It may be
necessary to tilt log #1 back slightly while placing log #2 on
the grate.
LOG # 3 (SRV397-703): Place log #3 on the right
side of the grate in front of log #1. The right edge of log #3
should touch the fi rebox while the rear lines up with the left
log. The left edge of log #3 should rest on the grate and log
#1 as shown.
1
2
3
TAB
TAB
1
2
3