Filter
Top Products
5
Door Closing and Door Alignment
The base grille covers the leveling screws and roller assemblies
located at the bottom of the refrigerator cabinet below the freezer
door or drawer. Before making adjustments, remove the base
grille and move the refrigerator to its
nal location.
1. Remove the base grille. Grasp the grille
rmly and pull it
toward you.
2. Move the refrigerator to its
nal location.
NOTE: To allow the refrigerator to roll easier, raise the leveling
legs o
the oor by turning the leveli
ng screws
counterclockwise. The front rollers will be touching the
r.
3. So the doors will close easier, use a ¹⁄
" hex driver to turn both
leveling screws clockwise. This will raise the front of the
refrigerator tilting it slightly downward to the rear. Turn both
leveling screws the same amount.
NOTE: Having someone push against the top of the
refrigerator takes some weight o
the leveling screws. This
makes it easier to turn the screws.
4. Open and close the doors to make sure t
hey close as easily as
you like. If not, increase the tilt by turning both leveling screws
clockwise. It may take several turns of the leveling screw to
allow the doors to close easier.
5. Check for door alignment. If one door is lower than the other,
adjust the leveling screw, on the lower side of the refrigerator.
Usi
ng a ¹⁄ " hex driver, turn the screw clockwise to raise that
side of the refrigerator until the doors are aligned. It may take
several turns of the leveling screw to raise the refrigerator.
NOTE: Havi
ng someone push against the top of the
refrigerator takes some weight o
the leveling screws. This
makes it easier to turn the screws.
6. Make sure the refrigerator is steady. If the refrigerator seems
unsteady or rolls forward when the door or drawer is opened
adjust the leveling screws. Using a ¹⁄
" hex driver, turn the
leveling screw on each side clockwise until the rollers are up
and the leveling feet are rmly against the or.
NOTE: Having someone push against the top of the
re
frigerator takes some weight
o
the leveling screws. This
makes it easier to turn the screws.
7. Replace the base grille by aligning the ends of the grille with
the leveling assemblies on each side and snapping the grille
into place.
A. Leveling screw
A
"
"