Filter
Top Products
23
Heat & Glo • VRTIKL-AU • 2123-900 • 7/07
B. Remove Shipping Materials
Remove shipping materials from inside or underneath the
fi rebox.
The gas line is shipped inside back panel. To access the
gas line remove the top plate from the gas stove. Remove
and retain the two Allen head screws that hold the back
panel in place. Replace panel when fi nished.
C. Unbolting Appliance from the Pallet
The gas stove is bolted and screwed to the pallet for ship-
ping. Use a 1/2 in. socket to remove the bolt in center of
bottom plate. Use a Phillips screwdriver to remove the
two screws in the front of the bottom plate and the two
screws holding the metal strap across the back of the gas
stove. Refer to Figure 7.2 for locations.
Figure 7.1
Figure 7.2
SECURING THE GAS STOVE
IS REQUIRED.
Figure 7.3
After unbolting the gas stove from the pallet, insert two
1/4 20 x 1-1/2 (or equivalent) counterscrews.
Using pliers, adjust the counterscrews to level the gas
stove.
ALLEN HEAD SCREWS
ALLEN HEAD SCREWS
LEVELING
LEVELING
SCREWS
SCREWS
LAG BOLT
LAG BOLT
HOLE
HOLE
D. Leveling and Lagging Down the Appliance
WARNING
Fire Risk.
Odor Risk.
Tipping Risk
• Install gas stove on a stable, level platform/
fl oor strong enough to support gas stove
without tipping.
• USE wood fl ooring, ceramic tile, brick hearth
or high pressure laminate fl ooring applied
directly over the sub-fl ooring material.
7
7
Appliance Setup
A. Remove Glass Door
Remove the front door assembly by pulling bottom of front
away from gas stove and lifting it off of the hooks on top of
the stove. Set door assembly aside.