Filter
Top Products
4. Remove the two leads from thermostat terminals and check for continuity across terminals. If continuity is not present
between thermostat terminals, replace thermostat. (See “Corrective Maintenance” section.)
5. If thermostat is good, check continuity of element. If continuity is not present, replace element.
IF OVEN OVERHEATS
1. If oven overheats, adjust thermostat. (See “Temperature Setting” section.)
2. If thermostat calibration fails to lower temperature, replace thermostat. (See “Corrective Maintenance” section.)
Corrective Maintenance
CHANGING ELEMENT
4. Disconnect wires on heating element.
1. Disconnect power source. 5. Remove old element and replace with new one
2. Remove two screws from bottom of oven. 6. Rewire as in diagram.
3. Remove bottom cover and insulation. 7. Replace insulation and oven bottom.
CHANGING THE THERMOSTAT
1. Disconnect from the power source.
2. Remove two screws from bottom of oven.
3. Remove bottom corner and insulation.
4. Disconnect wire terminals on thermostat.
5. Remove old thermostat and replace with new one.
6. Rewire as in diagram
7. Replace insulation and bottom, making sure wires are insulated from element.
Model K-50 Wiring Diagram