Filter
Top Products
12
56
Apply acrylic tape over pipe chase seam.
Tape is found with the ship loose items
and acts as a watershed preventing
water from settling in case joint.
Seal joints along pipe chase seam
with the caulk provided.
Now that cases have been positioned and leveled, you may proceed to trim-out case line-
up. Trim parts have been designed to be applied easily with only a small number of fas-
teners required. Most external parts are adjustable to achieve almost invisible, snug-fit-
ting joints and a high level of excellence in fit and finish.
TRIM OUT
BUMPER
SCREW
BUMPER
JOINT
1
Adjust polymer master bumper joints,
if required. First loosen bumper
screws.
2
Slide bumper joint to the center of the
joint between the two cases. Use
screw driver in hole provided.
3
Slide master bumper left or right to
close seam as required. Bumper joint
neatly finishes any gap that may
remain.
4
Close seam where bumper joins case
end. Bumper joint closes seam that
may develop if master bumper is
moved away from end to close case-
to-case joint seam.
ACRYLIC
TAPE
PIPE
CHASE