Filter
Top Products
– 5 –
ASSEMBLY
Check to assure the hub and hub drive are clean and clear of any obstruction. Insert the cylinder
assembly with a slight twisting motion toward the left. The cylinder stop pin will contact the side of the
hole that receives it. Tighten the thumb screw.
NOTE: Upon disassembly it is only necessary to loosen the thumb screw about three turns. It should
never be removed.
Slide the worm into the cylinder and rotate until the square shank of the worm locks into the hub drive.
Install the knife with cutting edges facing out, and the plate, making sure the notch aligns with the pin
in the bottom of the cylinder. Thread the adjusting ring on hand tight. Install the feed pan and feed
stomper.
NOTE: On the model 4822 with funnel-shaped cylinder, tighten the feed pan thumb screw (Fig. 2),
holding the pan securely to the chopper cylinder assembly.
CAUTION: The knife and plate depend on meat for lubrication. Therefore, the chopper should
never be operated without meat.
Fig. 2