Filter
Top Products
– 21 –
If the machine is equipped with gas heat, refer to STARTING THE GAS HEAT DISHWASHER below.
The tank water temperature is regulated by the solid-state thermostat. The thermostat is preset at the
factory and no adjustment should be required. If an adjustment is necessary or the machine is to
operate low temperature, contact your local Hobart service office. Use thermometers for verification
of proper water temperatures.
Minimum temperatures for all models are:
Single-Tank Models WASH TANK RINSE TANK FINAL RINSE
C44A/AW, C54A 160°F (Min.) –––– 180°F (Min.)
CRS66A/AW, CRS76A
CPW80A/AW, CPW90A
CCS66A/AW, CCS76A
Two-Tank Models
C64A, CRS86A, CCS86A, 150°F (Min.) 160°F (Min.) 180°F (Min.)
CPW100A, C88A, CRS110A,
CCS110A, CPW124A
Minimum temperatures for optional low-temperature operation are:
Wash Tank - 140°F Rinse Tank - 140°F Final Rinse - 140°F.
If the tank is accidentally drained before turning off the power switch, the float-controlled, low-water
protector switch will automatically stop the tank heat. When the proper water level is returned, the tank
heat will be automatically started. DO NOT use the low-water protection as a power on-off switch. The
heat MUST be turned OFF at the Power switch when the machine is not in use.
This machine must be operated with an automatic detergent feeder and, if applicable, an automatic
chemical sanitizer feeder, including a visual means to verify that detergents and sanitizers are
delivered or a visual or audible alarm to signal if detergents and sanitizers are not available for delivery
to the respective washing and sanitizing systems. See Plumbing Connection and Electrical Connections
for proper installation.
STARTING THE GAS HEAT DISHWASHER
1. STOP! Read the Safety Information on page 2 before operating this dishwasher.
2. Turn main gas supply to the dishwasher ON.
3. Wait for 5 minutes to clear out any gas. If you then smell gas, STOP! Follow all safety information
covered on page 2 in Important for Your Safety.
4. If you don't smell gas, turn the manual gas valve On.
5. Turn the Power switch ON (Fig. 1). Dishwasher will fill automatically (refer to Auto Fill). When tank
is filled, the burner will ignite, if heat is required. (The ignition system includes a 15-second pre-
purge period before ignition occurs.)
6. If the dishwasher will not operate, follow the instructions below to turn off the gas to the
dishwasher. Call your local Hobart service office or gas supplier.
To Turn the Gas-Powered Dishwasher Off:
Turn the Power switch OFF. Turn the manual gas valve Off.