Hobart C64A ML-103908 Dishwasher User Manual


 
– 6 –
Thermometers
Dial thermometers for wash and final rinse are indicated in °F and °C on the faceplate.
Door Interlocks
Door interlock switches will prevent machine operation while an inspection door is open. If a door is
opened while the machine is operating, the pumps and conveyor will automatically turn off. After the
door is closed, the machine must be restarted by pushing the Motor switch ON.
Wash and Rinse Arms
Upper and lower prewash, wash and final rinse arms are removable.
RS Unit and CS Unit (CRS66A, CRS66AW, CRS76A, CRS86A, CRS110A, CCS66A,
CCS66AW, CCS76A, CCS86A and CCS110A)
The 22" Recirculating Scrapper is a power prewash unit which uses overflow wash water, hence, no
fill valve is required.
PW Unit (CPW80A, CPW80AW, CPW90A, CPW100A and CPW124A)
The 36" prewash unit is a large power prewash unit which uses overflow wash water, hence, no fill valve
is required.
Auto Fill
Close door(s) and push the Power switch ON. After a 5-second delay, the machine fills automatically.
Auto Timer
The Auto Timer switch is located on the left side of the control box. Designed to save electrical power,
it is adjusted to shut off pump and drive motors a set amount of time after the last rack exits the
dishwasher. To restart, slide a rack into the machine or push the Motor switch ON. To change the time
setting, contact your local Hobart-authorized service office.
Common Drain
A stainless steel common drain tube connects the dishwasher and prewash drains together, thus
requiring only one drain connection at installation.
Front Panel
Stainless steel front panel conceals pumps and plumbing.
Common Water Connection
A single water connection for fill and final rinse is standard. This requires a minimum incoming water
temperature of 180°F for high-temperature machines (140°F for low-temperature machines) for
machines not equipped with booster heater. A minimum incoming water temperature of 110°F is
required for machines equipped with an optional 30
KW Hobart booster heater, and a minimum
incoming water temperature of 140°F is required for machines equipped with an optional 15
KW Hobart
booster heater.