Hobart DGC501 Convection Oven User Manual


  Open as PDF
of 4
 
701 S Ridge Avenue, Troy, OH 45374
1-888-4HOBART • www.hobartcorp.com
Page 4 of 4 F-39821 – DGC5 Series Gas Convection Ovens
As continued product improvement is a policy of Hobart, specifications are subject to change without notice.
Printed On Recycled Paper
DGC5 SERIES GAS
CONVECTION OVENS
F-39821 (REV. 05/07) LITHO IN U.S.A. (H-01)
SPECIFICATIONS
General: Gas convection oven. Basic section
(DGC5) is without legs; may be ordered separately
for replacement, for stacking 2-high or for mounting
on legs. DGC501 single basic section on 25
3
⁄4" legs.
DGC502 two basic DGC5 sections on 8" legs.
Construction: Stainless steel front, sides and top,
painted legs. Porcelain enamel on steel oven
interior. Independently operated solid stainless steel
doors open a full 180 degrees. Two interior oven
lights per section. Non-sag insulation applied to the
top, rear and sides, bottom and doors.
Oven interior measures 29" w x 22
1
⁄8" d x 20"h. Five
nickel plated oven racks per section measure 28
1
⁄4" x
20
1
⁄2". Eleven position nickel plated rack guides with
positive rack stops per section.
Controls: Side mounted solid state temperature
controls adjust from 150° to 500°F. 60-minute timer
with audible alarm. Oven cool switch for rapid cool
down.
Gas: One 44,000 BTU/hr. burner per section. 88,000
BTU/hr. for Model DGC502. Electronic spark igniter.
Electrical: Two-speed
1
⁄2 H.P. oven blower motor per
section. 115/60/1 power supply required. 6 foot cord
and plug. 9 amps total draw.
IMPORTANT
WHEN ORDERING: The following must be specified:
1) The type of gas
2) The altitude when above 2,000 ft.
 previous