Filter
Top Products
– 7 –
FLUE CONNECTIONS
The fryer must be located under a hood with adequate connection to an exhaust duct. The hood must
extend 6" (15 cm) beyond fryer sides.
Adequate ventilation must be provided and comply with
Vapor Removal from Cooking Equipment,
ANSI-NFPA Standard #96 (latest edition), available from the National Fire Protection Association,
Batterymarch Park, Quincy, MA 02269.
Clearance above the fryer should be adequate for combustion by-products to be removed efficiently.
An 18" (46 cm) minimum clearance should be maintained between the flue vent and the filters of the hood
venting system. Never make flue connections directly to the fryer.
Do not obstruct the flow of the flue gases from the appliance. Proper air balance should be maintained
in the room.
ELECTRICAL CONNECTIONS
WARNING: ELECTRICAL AND GROUNDING CONNECTIONS MUST COMPLY WITH THE
NATIONAL ELECTRICAL CODE AND/OR OTHER LOCAL CODES.
WARNING: APPLIANCES EQUIPPED WITH ELECTRICAL SUPPLY CORD(S) ARE PROVIDED
WITH A THREE-PRONG GROUNDING PLUG, WHICH MUST BE CONNECTED TO A PROPERLY
GROUNDED RECEPTACLE. IF THE RECEPTACLE IS NOT THE PROPER GROUNDING TYPE,
CONTACT AN ELECTRICIAN. DO NOT REMOVE THE GROUNDING PRONG FROM THE PLUG.
Fryers are equipped with a 120 V, 60 Hz, 1-phase cord and plug.
Do not connect fryer to electrical supply until after gas connections have been made.