Filter
Top Products
– 4 –
Installation, Operation and Care of
HHFC SERIES DELI DISPLAY CASES
SAVE THESE INSTRUCTIONS
GENERAL
The HHFC Series Deli Display Cases hold food products at regulated temperatures, maintaining both
freshness and quality. The deli cases feature uniform heating. Clear-view glass surrounds the food
holding area. Full Service units provide the customer a full view of the displayed food products. Self-
Service or Partial Self-Service units provide an opening to permit the customer to get-it-and-go.
Overhead radiant heater and halogen lighting is standard. Overhead radiant heat lamp bulbs are
optional.
The deli cases have an easily accessible control panel and hold a variety of pan configurations.
INSTALLATION
Prior to installation, check the electrical service to make sure that it agrees with the specifications on
the data plate located on the electrical inspection plate beside the controls.
UNPACKING
Immediately after unpacking the deli case, check for possible shipping damage. If the deli case is found
to be damaged, save the packaging material and contact the carrier within 15 days of delivery.
The deli case is shipped on a full skid and is wood crated. All deli case components, such as side glass,
divider bars and bulbs, are separately boxed and shipped in the well area of the deli case.
1. Remove the top part of the crate first.
2. Remove the side parts of the crate.
3. Remove the PVC shrink-wrap material from around the unit. Care should be taken when removing
the protective shrink-wrap material.
4. Remove the end parts of the crate.
5. The glass side panels are packed in a separate carton and must be installed. The carton containing
the glass panels is secured in the well of the deli case. Take care when opening the carton to avoid
possible damage or breakage to the glass.
6. To remove the deli case from the shipping skid:
On a Countertop Model, cut and remove the retaining bands that secure the unit to the skid.
On display cases intended to be set on the floor, remove the retaining bolts located in each corner
of the base of the deli case.
Depending on the model of the deli case, it may be necessary to remove the sandwich preparation
board first. To remove the sandwich preparation board, place the board in its down position. The
board can then be lifted in an upward direction and removed from the hinging mechanism. It is not
necessary to remove any screws or the hinging mechanism.
LOCATION
The installation location must allow adequate clearances for servicing and proper operation.