Filter
Top Products
701 S Ridge Avenue, Troy, OH 45374
1-888-4HOBART • www.hobartcorp.com
F-7533 – N50 Mixer Page 3 of 4
N50
MIXER
SPECIFICATIONS
MOTOR:
1
⁄6 H.P., Hobart designed, ventilated, sleeve bearing,
drip-proof enclosure.
Single Phase 100-120V 2.9 Amps
230V 1.4 Amps
ELECTRICAL:
100-120/60/1 - U L Listed for residential and
commercial use. Also available in 100/50/1,
230/50/1, 220/60/1 and 230/60/1 - not submitted
for U L Listing.
CONTROLS:
Single pole, toggle-type, mechanically interlocked
with transmission shift handle. Includes automatic
circuit breaker with manual reset switch.
TRANSMISSION:
Three speed selection transmission. Convenient
shift handle mounted near “OFF” and “ON” switch.
SPEEDS:
Three positive speeds - Low, Intermediate, and High.
BOWL AND BEATERS:
Bowl is 5-quart capacity stainless steel. Locks at
top and bottom of lift travel, which is controlled by
convenient hand lever. A stainless steel beater is also
available.
FINISH:
Hybrid Powder Coat nish available in Hobart Gray.
STANDARD EQUIPMENT:
Consists of the mixer unit with one (1) 5-quart
stainless steel bowl, one (1) “B” at beater, one (1)
“D” wire whip, one (1) “ED” dough hook, cord and
plug.
ATTACHMENT HUB:
Equipped with front-mounted Hobart standard #10
taper attachment hub, and any #10 size attachments
may be used.
ATTACHMENTS AND ACCESSORIES:
The following are available at extra cost:
Stainless Steel Bowl
“B” Flat Beater
Stainless Steel “B” Flat Beater
“D” Wire Whip
“ED” Dough Hook
LISTED BY: Underwriters Laboratories, Inc. and NSF International.
Agitator
(RPM)
Attachment
(RPM)
Low 136 60
Intermediate 281 124
High 580 255