Filter
Top Products
16
8) Move the control switch to the "OFF" position. Remove the upper front, top and left side
panels.
9) Move the power switch to the "OFF" postion. Unplug the icemaker from the electrical
outlet.
10) Disconnect the ice transport hose from the spout, and pour fresh water into the ice
transport hose to rinse out the solution and ll the evaporator and reservoir. Be careful
not to overll the reservoir. Reconnect the transport hose.
11) Plug the icemaker back in. Move the power switch to the "ON" position and replace the
panels in their correct positions.
12) Move the control switch to the "ICE" position. Run the icemaker until it stops
automatically.
13) Move the control switch to the "DRAIN" position, and wait about 15 minutes for the
water system to drain.
14) After the water has drained, move the control switch to the "OFF" position. Remove the
upper front, top and left side panels.
15) Move the power switch to the "OFF" position. Unplug the icemaker from the electrical
outlet.
16) Open the water supply line shut-off valve. Check for water leaks.
17) Plug the icemaker back in. Move the power switch to the "ON" position and replace the
panels in their correct positions.
18) Move the control switch to the "ICE" position and run the icemaker about 30 minutes.
19) Move the control switch to the "OFF" position.
20) Activate the dispense sensor to remove the ice from the storage bin. Remove the upper
front, top and left side panels.
21) Move the power switch to the "OFF" position. Unplug the icemaker from the electrical
outlet.
22) Remove the front cover of the storage bin. Pour warm water into the storage bin to melt
any remaining ice.
23) Clean the storage bin with water.
WARNING
Do not use ice produced from the cleaning and sanitizing solution. Be sure no
ice remains in the storage bin.
24) Replace the front cover of the storage bin, then plug the icemaker back in. Move the
power switch to the "ON" position and replace the panels in their correct positions.
25) Move the control switch to the "DRAIN" position, and wait about 15 minutes for the
water system to drain.
Note: If cleaning the dispensing components, proceed to "B. Cleaning and Sanitizing
Instructions - Dispensing Components."
26) After the water has drained, move the control switch to the "ICE" position to start the
automatic icemaking process.