Filter
Top Products
8
* The icemaker requires no clearance at either side. But allow enough space at rear for
water supply and drain connections, at least 12” (approx. 30 cm) clearance at front, and
at least 0.6” (approx. 15 mm) clearance at top for maintenance.
D. Electrical Connection
WARNING
THIS APPLIANCE MUST BE GROUNDED.
This icemaker requires a ground that meets the national and local electrical
code requirements. To prevent possible severe electrical shock injury to
individuals or extensive damage to equipment, install a proper ground wire
to this icemaker. Remove the plug from the electrical outlet before any
maintenance, repairs or cleaning is undertaken.
CAUTION
The GREEN ground wire in the factory-installed power cord is connected to
a screw on the bracket where the cord enters the machine. If it becomes
necessary to remove or replace the power cord, be sure to connect the power
cord’s ground wire to this screw upon reattachment.
* This icemaker must be plugged into an independent power receptacle which has enough
capacity. The maximum allowable voltage variation should not exceed ± 10 percent of the
nameplate rating. See the Nameplate.
* Usually an electrical permit and services of a licensed electrician are required.
E. Set Up
IMPORTANT
Do not place heavy objects exceeding 33 lbs (15 kg) on the Top Panel.
1) Unpack the icemaker, and remove all shipping cartons, tapes and packing BEFORE
operating the unit.
2) Position the icemaker in a selected site. Clean the interior with soap and water and
rinse thoroughly.
3) Level the icemaker in both the left-to-right and the front-to-rear directions (when installed
with or without legs). See Fig. 2.