Filter
Top Products
13
G. Startup
CAUTION
1. All parts are factory-adjusted. Improper adjustments may result in failure.
2. If the unit is turned off, wait for at least 3 minutes before restarting the
icemaker to prevent damage to the compressor.
1) Open the water supply line shut-off valve.
2) Remove the front panel.
3) Move the control switch on the control box to the "ICE" position.
4) Let the icemaker run for 10 minutes, then move the control switch to the "OFF" position.
5) Open the door.
6) Disconnect the suction hose to drain the water. See Fig. 3.
7) Reconnect the suction hose back in its correct position
after all of the water has drained.
8) Clean the storage bin.
9) Move the control switch to the "ICE" position. This starts
the automatic icemaking process.
11) Close the door.
12) Place the front panel in its correct position.
Fig. 3
Suction Hose
Water Tank
Drain
Pan