Filter
Top Products
11
II. Installation and Operating Instructions
WARNING
1. This icemaker must be installed in accordance with applicable national, state,
and local regulations.
2. CHOKING HAZARD: Ensure all components, fasteners, and thumbscrews
are securely in place after installation. Make sure that none have fallen into
the storage bin.
A. Checks Before Installation
• Visually inspect the exterior of the shipping container and immediately report any
damage to the carrier. Upon opening the container, any concealed damage should also
be immediately reported to the carrier.
• Remove the shipping carton, tape, and packing material. If any are left in the icemaker,
it will not work properly.
• Remove the panels to prevent damage when installing the icemaker. See "II.B. How to
Remove Panels."
• Remove the package containing the accessories.
• Remove the protective plastic lm from the panels. If the icemaker is exposed to the
sun or to heat, remove the lm after the icemaker cools.
• Check that the refrigerant lines do not rub or touch lines or other surfaces, and that the
fan blade (if applicable) turns freely.
• Check that the compressor is snug on all mounting pads.
• See the nameplate on the rear panel, and check that your voltage supplied
corresponds with the voltage specied on the nameplate.
• This icemaker can be installed on a storage bin 30" wide or wider with a depth of 40" or
greater.
• On remote air-cooled model, a remote condenser unit is needed. Hoshizaki Remote
Condenser Unit, Model URC-22F is recommended.
B. How to Remove Panels
See Fig. 1
• Front Panel: Remove the 2 screws. Lift
up and towards you.
• Top Panel: Remove the 2 screws, and lift off.
• Side Panel (R): Remove the screw. Slide
forward slightly and lift off.
• Side Panel (L): Remove the 6 screws,
and lift off.
• Rear Panel: Remove the 6 screws, and
lift off.
• Insulation Panel: Remove the
thumbscrew. Lift up slightly and pull
towards you.
Fig. 1
Top Panel
Insulation
Panel
Front Panel
Side Panel (R)
Side Panel (L)
Top
Insulation
Rear
Panel