Hotpoint 22 Refrigerator User Manual


 
11
Installation
Refrigerator
Instructions
Models 22 and 25
CLEARANCES
Allow the following clearances for ease of installation,
proper air circulation and plumbing and electrical
connections.
Sides 1/8″ (4 mm)
Top 1″ (25 mm)
Back 1″ (25 mm)
If the refrigerator is against a wall on either side, allow
a 1/8 (3 mm) door clearance.
REFRIGERATOR LOCATION
Do not install the refrigerator where the temperature
will go below 60°F (16°C) because it will not run
often enough to maintain proper temperatures.
Do not install the refrigerator where the temperature
will go above 100°F (37°C) because it will not
perform properly.
Install it on a floor strong enough to support it fully
loaded.
WATER SUPPLY TO THE ICEMAKER
(ON SOME MODELS)
If the refrigerator has an icemaker, it will have to be
connected to a cold water line. A water supply kit
(containing tubing, shutoff valve, fittings and
instructions) is available at extra cost from your dealer,
or from Parts and Accessories, 800.626.2002.
ROLLERS
The rollers have 3 purposes:
Rollers adjust so the doors close on their own when
opened about 45°.
Rollers adjust so the refrigerator is firmly positioned
on the floor and does not wobble.
Rollers allow you to move the refrigerator away from
the wall for cleaning.
To adjust the rollers:
Remove the base grille by
positioning hands as shown.
Rotate the bottom of the
grille outward until the clips
snap out.
Pull the grille away from the
refrigerator.
Using a screwdriver, turn
the two front roller adjusting
screws clockwise to raise
the refrigerator,
counterclockwise to lower it.
Replace the grille so the
notch in the grille will fit
around the bottom door
hinge.
Tilt the top of the grille
toward the refrigerator and
insert the long metal clips
into the top of the oval
openings at the bottom of
the refrigerator.
Rotate the bottom of the grille toward
the refrigerator until it snaps into place.
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT – Save these
instructions for local inspector’s use.
IMPORTANT – Observe all
governing codes and ordinances.
Note to Installer – Be sure to leave these
instructions with the Consumer.
Note to Consumer – Keep these instructions
for future reference.
Skill level – Installation of this appliance requires
basic mechanical skills.
Completion time – Refrigerator Installation
15 minutes
Proper installation is the responsibility
of the installer.
Product failure due to improper installation
is not covered under the Warranty.
Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: www.Hotpoint.com