Filter
Top Products
8
EN
Starting the dishwasher
1. Turn the water tap on.
2. Open the door and press the ON/OFF button: the
indicator light will illuminate.
3. Measure out the detergent (see below).
4. Load the racks (see Loading the racks).
5. Select the programme by pressing the WASH
CYCLE SELECT button; the corresponding indicator
light will illuminate.
6. Select the wash options (see below).
7. Start the wash cycle by shutting the door: the
machine will emit a confirmation beep.
8. At the end of the cycle two short beeps will sound
and the WASH CYCLE indicator light will flash. Open
the door, switch off the appliance by pressing the
ON/OFF button, shut off the water tap and unplug
the appliance from the electricity socket.
9. Wait for a few minutes before removing the
crockery, in order to avoid burns. Unload the racks,
beginning with the lower level.
Modifying a wash cycle in progress
If a mistake was made during the wash cycle
selection process it is possible to change the cycle,
provided that it has only just begun: open the door,
taking care to avoid the escaping steam, and press
the WASH CYCLE SELECT button, holding it for 4
seconds. After one long beep and three short
beeps, the WASH CYCLE indicator light will switch
off: select the new wash cycle and start the
programme by shutting the door.
Adding extra crockery
Open the door, taking care to avoid the escaping
steam, and place the crockery inside the
dishwasher. Close the door: the cycle starts from the
point at which it was interrupted.
Accidental interruptions
If the door is opened during the wash cycle, or if
there is a power cut, the cycle stops. It starts again
from the point at which it was interrupted once the
door has been shut or the electricity supply is
restored.
Loading the detergent
A successful wash also depends on the correct
amount of detergent being used, as recommended
by the manufacturer. Exceeding the recommended
amount does not result in a more effective wash and
pollutes the environment.
To obtain the best results from each washing and
drying cycle, powder detergent, rinse aid liquid and
salt should be used.
comparcompar
comparcompar
compar
tment Atment A
tment Atment A
tment A: Washing detergent
comparcompar
comparcompar
compar
tment Btment B
tment Btment B
tment B: Pre-wash detergent
1. Open cover C by
pressing button D.
2. Pour in the detergent
after consulting the
Wash
cycle table
:
• for powder detergent
use compartments A and
B
• for tablets, use
compartment A and the
bottom of the appliance,
i.e. when the cycle requires 1 tablet, place it in
compartment A and close the cover; when it requires
2, place the second tablet at the bottom of the
appliance.
3. Remove detergent residues from the edges of the
compartment and close the cover until it clicks.
Washing options
Extra drying*
To make sure that the crockery is completely dry at
the end of the cycle, press the EXTRA DRYING
button before selecting the wash cycle. A prolonged
beep will sound to indicate that this option has been
selected and a short beep will sound to indicate
when it has been deselected.
This option is incompatible with the soak cycle.
If the Extra drying option is selected, the wash
cycles will last longer.
A
B
D
C
Start-up and use
* Only available in selected models.