Hotpoint BU82SS Double Oven User Manual


 
GB
25
Care and Cleaning
(UQ47I/2 / UE47X/2 / AHP37X/1)
CLEANING THE DOORS
Take particular care not to damage the inner
surface of the door inner glass that is coated with
a heat reflective layer. Do not use scouring pads,
or abrasive powder, which will scratch the glass.
Ensure that the glass panel is not subjected to
any sharp mechanical blows.
Stubborn stains can be removed by using a fine
steel wool soap pad. For slight soiling the inner
glass panel may be cleaned, while still warm,
without removing it from the door. After cleaning,
rinse and dry with a soft cloth.
DROP DOWN DOORS
Remove the door inner glass as follows.
1. Open the door fully and remove the extrusion end
caps (This should be done by hand but if it proves
too difficult, simply lift the inner glass to ease the
end caps out of position).
NOTE: If you need to use a tool - be careful
not to damage the extrusion or end cap.
Top filler cap Remove both screws to
remove top filler cap
2. Carefully slide the inner glass towards you and
withdraw it from its locating slots. Ensure that the
door is not allowed to slam shut, due to the
reduction in door weight. Clean the glass as
described above.
3. The inside of the outer door glass can now be
cleaned while still fitted to the cooker.
NEVER OPERATE THE COOKER WITHOUT THE
INNER DOOR GLASS IN POSITION.
Refit the door inner glass as follows.
1. Open the door fully.
2. Locate the inner door glass into its slots. The inner
door glass has a special reflective coating on one
side, in order to minimise surface temperatures
and energy consumption during use, it is important
it is fitted correctly.
3. Carefully slide the glass into its slots as far as it
will go and replace the top filler cap.
Disposal of your product
To minimise the risk of injury to children please
dispose of your product carefully and safely.
Remove all doors and lids. Remove the mains cable
(where fitted) by cutting off flush with the appliance
and always ensure that no plug is left in a condition
where it could be connected to the electricity
supply.
To help the environment, Local Authority instructions
should be followed for the disposal of your product.
Disposal of old electrical appliances
The European Directive 2002/96/EC on Waste
Electrical and Electronic Equipment (WEEE),
requires that old household electrical appliances
must not be disposed of in the normal unsorted
municipal waste stream. Old appliances must be
collected separately in order to optimise the
recovery and recycling of the materials they contain
and reduce the impact on human health and the
environment.
The crossed out "wheeled bin" symbol on the
product reminds you of your obligation, that when
you dispose of the appliance it must be separately
collected.
Consumers should contact their local authority or
retailer for information concerning the correct
disposal of their old appliance.