Filter
Top Products
CONNECT TO THE WATER SUPPLY...
● For your machine to operate correctly
it requires water pressures in the range
of 6-150 psi (100-1000 KPa).Most
cold water supplies will be in this
range.
● Note:Low water pressure will lead to
excessively long fill times or no fill.
● Ensure that the new hose supplied is
connected and the old hose is disposed
of safely.
● Ensure the fill hose is only connected
to the cold water supply.
WARNING
● Ensure the fill hose is NOT kinked.
Note:Do not over tighten the hose
connector.Hand tight is sufficient.
● Tap connections (if applicable) - A
range of adaptors are available to suit
your tap.
WARNING
● Do not connect appliance to a single
outlet instantaneous water heater or
an electric heater.
Remember you may be charged for a
service call if a problem with your
appliance is caused by incorrect
installation or misuse.
CHECKLIST...
When you have installed your appliance,
ensure it is ready to use by following this
Check List:
1. Dispose of packaging safely,see
‘Recycling Information’on page 2.
2. Position appliance close to
electrical/water supply see ‘Choose a
Location’on page 4.
3. Connect supplied hose to appliance
water supply,confirm water is flowing
before connecting to the appliance
inlet valve see ‘Connect to a Water
Supply’,page 6.
4. Untie drainage hose at rear of
appliance and connect to either a
standpipe or sink waste drainage
system see ‘Connect to a Drainage
System’page 5.
5. Untie mains lead at rear of appliance
and plug into electrical supply via a
switched socket,see ‘Electrical
Supply’on page 3.
6. Position appliance,taking care not to
kink or damage hose at rear of
appliance.
7. Stabilise the appliance,see ‘Adjusting
the Feet’page 4.
8. Turn on the water supply to the
appliance.
9. Switch on at plug socket.
Your appliance is now ready for use,refer to
‘Getting to know your Appliance’on page 7 to
familiarise yourself with the appliance.
Installation...
6
FP105-01 DWF35/34/33/30 12/02/2002 10:22 am Page 6