Hotpoint FDUD 44110 ULTIMA Dishwasher User Manual


  Open as PDF
of 20
 
12
GB
Special wash cycles and Options
Short Time
This option can be used to reduce the duration of
the main wash cycles while, maintaining the same washing
and drying performance levels. After selecting the wash
cycle,presstheSHORTTIMEbutton;theilluminationofthe
corresponding indicator light indicates its selection. Press
it again to deselect it.
Extra drying*
To improve the dryness level of the crockery, press
theEXTRADRYINGbuttonandthesymbolwill
light up. If it is pressed again, the option will be deselected.
A higher temperature during the final rinsing and a longer
drying phase improve the dryness level.
The EXTRA DRYING option increases the duration of
the wash cycle.
Multi-functional tablets* (Tabs)
This option optimises washing and drying results.
Whenusingmulti-functionaltablets,presstheMULTI-
FUNCTIONALTABLETSbutton;thecorrespondingsymbol
will light up. If the button is pressed again, the option will
be deselected.
The “Multi-functional tablets” option results in a longer
wash cycle.
The use of tablets is only recommended for models
having this option and it is not recommended with wash
cycles which do not specify the use of multi-functional
tablets.
Wash options*
The OPTIONS may only be set, changed or reset after
the wash cycle has been selected and before the Start/
Pause button has been pressed.
Onlytheoptionswhicharecompatiblewiththetypeofwash
cycle set may be selected. If an option is not compatible
with the selected wash cycle
(see Table of wash cycles)
, the
corresponding symbol flashes rapidly 3 times.
If an option is selected which is not compatible with another
(previously selected) option, it will flash 3 times and switch
off, while the most recently selected option will remain active.
To deselect an option which has been set by mistake, press
the corresponding button again.
Notes:
Optimumperformancelevelswhenusingthe“Fastwash”
and“Express30’”cyclescanbeachievedbyrespectingthe
specified number of place settings.
*TheEcowashcyclecomplieswithregulationEN-50242.
Although it has a longer duration than other wash cycles, it uses
less energy and is less harmful to the environment.
Note for Test Laboratories: forinformationoncomparativeEN
testing conditions, please send an email to the following address:
ASSISTENZA_EN_LVS@indesitcompany.com
Zone Wash*
This option makes it possible to carry out the wash
cycle in the selected rack only. Select the wash
cycleandthenpresstheZONEWASHbutton:theselected
rack lights up and the wash cycle starts in the selected rack
only. Press the button again to deselect the option.
The option is available with the following wash cycles:
IntensiveandNormal.
SelecttheoptionandtheIntensivecycletostartthePOWER
ZONEwashing.Thiswashcycleisidealforverysoiled
mixed loads, e.g. pans and saucepans, dishes with heavy
encrustation or difficult-to-clean crockery (grater, vegetable
mill, dirty cutlery). The spraying pressure is stronger and the
washing temperature higher, thus ensuring optimum handling
of stubborn stains.
SelecttheoptionandtheNormalcycletostarttheGREEN
ZONEwashing.Thisfunctionmakesitpossibletoreduce
water and energy consumption, thus achieving excellent
washinganddryingresults.Cycledurationislonger.
Remember to load the crockery in the selected rack only.
Delayed Start option
It is possible to delay the start time of the cycle by a period
of time between 1 and 24 hours:
1.Selectthedesiredwashcycleandanyotheroptions
required.PresstheDELAYEDSTARTarrowstoselectwhen
thewashcycleistostart(1h,2hetc.)
2.ConfirmthechoiceusingtheSTART/PAUSEbutton:the
countdown begins and the display shows Begins in ...
3.Oncethistimehaselapsed,theDELAYEDSTARTsymbol
switches off and the wash cycle begins.
TodeselecttheDELAYEDSTARToption,presstheDELAYED
STARTbuttonuntilthetextOFF appears.
The Delayed Start function cannot be set once a wash
cycle has been started.
 previous next