Filter
Top Products
20
D
ISHWASHER
Fault Area
Issue Cause/How to resolve…
Poor Drying Results
Is Rinse Aid being used or is the
Rinse Aid level set too low?
Using rinse aid in your wash will improve the drying performance.
To add rinse aid to your wash follow instructions below:
Step 1: Rotate cap anti-clockwise and pull to remove.
Step 2: Pour rinse aid into container and secure cap back into position.
&DS
The level of rinse aid used during your wash cycle can be adjusted to
ensure best results.
Rinse Aid Levels 1 (lowest) to 6 (Highest)
Rinse Aid level adjuster is located under
dispenser cap. Using small coin rotate
adjuster to desired setting.
(We recommend setting to 4).
Rinse Aid Adjuster
The Dishwasher Will Not
Drain
Possible Installation Fault
(Particularly if the machine is being
used for the first time)
Check
- Is the drain hose kinked?
- Is the sink trap blocked? (If this is the case you will experience
problems whit your sink drainage).
- Ensure the blanking plug/closed end connector has been removed
if connected to a sink trap (this is the most common fault when installing
a dishwasher).
Remove blanking
plug/closed end
connection from
sink trap.
Ensure drain
hose is not
kinked
Note:
There are two types of sink trap
drain hose connection.
1. Closed end connection:
Which must be cut off.
2. Blanking plug in the sink trap
connections:
Which must be removed.
Which must be removed.