Filter
Top Products
16
D
ISHWASHER
Rinse Aid Light Flashing/
Not Going Out When Rinse
Aid Added
Fault Area
Issue
Cause/How to resolve…
Rinse Aid light will flash if:-
- S You are using the Machine for
the first time.
Or
- The rinse aid level is low.
The Rinse Aid light will flash when your dishwasher is switched on for
the first time and again when the rinse aid levels become low - follow the
instructions on “Before Using Your Dishwasher “ page on how to add
rinse aid..
Please Note:
- The rinse aid light will remain lit after the rinse aid
has been added, and will continue to flash until the
machine has completed the next full wash cycle
(Note: The Fast & Prewash cycles are not full wash
cycles).
- If you are using 3 in 1 tablets (or 2 in 1) and do not
add rinse aid then the rinse aid light will flash
continuously.
Leaking From Rear Of
Machineeaking
Possible Incorrect Fitment of Water
Inlet HosePossi
ChCheck
Is the water inlet hose connection secured at rear of machine (Fig1)
and has filter washer (A) been fitted (Fig2)?
Filter washer (A) can be
found with the Instruction
Book when the machine is
delivered. Fil F
Fig.1
Fig.2
Machine Connection Tap Connection
Cycle Indicator Lights
FlashingC
Your dishwasher is designed so that if a fault occurs, an error message indicated by one
or two wash cycle indicator lights flashing rapidly.
In many cases you can rectify these errors by following instructions in this section.
If however the errors indicated on your machine are not listed, you will need to contact your Service Centre
for assistance.
See “Key Contacts” on the back page of the instruction book.
Short beeps sounding for
a few minutes when starting
programme.
- Water tap turned off
- Turn on the water tap and the dishwasher will start after a few
minutes.