Hotpoint FDW 75 Dishwasher User Manual


 
5
EN
Anti-flooding protection*
To ensure floods do not occur, the dishwasher:
- is provided with a special system which blocks the
water supply in the event of anomalies or leaks from
inside the appliance.
- is provided with a
Water Stop
* safety device, in other
words it has a water inlet hose that consists of a
transparent hose on the outside and a red hose on the
inside: both the hoses can withstand extremely high
pressure. If the internal hose breaks, the external hose
becomes a bright red colour and carries the water
instead, thus avoiding any leakage.
! It is very important to check the external hose
regularly: if it is a bright red colour, it must be replaced
by an authorised technician as soon as possible (
see
Assistance
).
* Only available in selected models.
Sink Waste System
For under sink drainage:
before connecting the drain hose, remove any
internal restrictions; this will prevent a build up of
debris which could cause a blockage
remove any restrictions from the waste spigot and
ensure that the sealing bung is removed
the hose should be routed, such that it is raised
to a minimum height of 800mm (31/2”).
! Ensure the sink outlet pipe has a minimum diamtere
of 32mm.
• Untie the end of the
GREY drainage hose from
the rear of the appliance.
• Reposition the ‘Hooked
End Support’ as required
along the GREY drainage
hose.
• If fitting an under sink waste disposal unit, cut out
the membrane, bung or blanking plug.
! Ensure the drain hose is securely attached, to
prevent it coming away while the machine is in use
and causing a flood.