Hotpoint FFA70 Refrigerator User Manual


 
Door Reversal
20
Door Reversal continued...
Refit Lower Door
12. Take off the two screw covers from the left hand centre panel and remove
the two screws. Fit these screws and covers over on the right hand side.
13. Fit the centre hinge on the left hand side with the original screws,cover the
screws with the original covers.
14. Using a thin blunt instrument, remove the hinge
bush cap from the top left of the lower door and fit
on the top right.
Note : You may require assistance to do this:
15. Place the lower door onto the lower hinge pin.
16. Offer the door up to the centre hinge.
Put the hinge pin through the centre hinge and
ensure it locates into the door. Check that the hinge
pin is positioned the right way up.
Refit Top Door
17. Using a thin blunt instrument, remove the hinge
bush cap from the top left of the door and refit on
the top right.
18. Replace the spacing washers onto the centre hinge bracket.
Note : You may require assistance to do this:
20. If necessary, slacken off the screws on the centre hinge pin and adjust the
doors so that they line up with the cabinet.
21. Adjust the front feet (see ‘Levelling’ SAFETY & INSTALLATION section).
22. Fit the bottom hinge covers (see ‘Hinge Covers’in the SAFETY &
INSTALLATION section).
Note : Let the appliance stand upright in it’s final location for at least 15
minutes before plugging in and switching on the electricity supply.
11. Screw the bottom hinge pin complete with spacing washers,
into the left hinge bracket.
19. Place the top door hinge onto the top left of the door, slide the
door onto the centre hinge pin. Support the door while
screwing the top hinge into position.
Ensure that the hinge bracket locates correctly.
CLEANING &
MAINTENANCE