Hotpoint FFM91 Freezer User Manual


 
Door Reversal
18
CLEANING &
MAINTENANCE
Refit Lower Door
17. Take off the two screw covers from the left hand centre panel and remove the two screws.
Fit these screws and covers over on the right hand side.
18. Fit the centre hinge on the left hand side with the original screws and cover the screws with
the original covers.
19. Using a thin blunt instrument, remove the hinge bush cap from the top
left of the lower door and fit on the top right.
Note : You may require assistance to do this:
20. Place the lower door onto the lower hinge pin.
21. Offer the door up to the centre hinge and ensure it locates into the door.
Check that the hinge pin is positioned the right way up.
Refit Top Door
22. Using a thin blunt instrument, remove the hinge bush cap from the top
left of the door and refit on the top right.
23. Replace the spacing washers onto the centre hinge bracket.
Note : You may require assistance to do this:
24. Place the top hinge onto the top left of the door, slide the door onto the centre
hinge pin. Support the door while screwing the top hinge into position.
Ensure that the hinge bracket locates correctly.
25. If necessary, slacken off the screws on the centre hinge pin and adjust the doors so that they
line up with the cabinet.
26. Adjust the front feet (see ‘Levelling’ SAFETY & INSTALLATION section).
WARNING: Failure to level the appliance correctly may result in misalignment of the cabinet
and/or doors.
Note : Let the appliance stand upright in it’s final location for at least 15 minutes before
plugging in and switching on the electricity supply.
14. Turn the handle vertically, top to bottom and place against the right hand side.
15. Secure the handle in place with the original fixing screws.
Door Handle Reversal
12. Remove the hole plugs from the right hand side of the door.
13. Unscrew the handle fixing screws and carefully remove the handle from the door.
16. Use the hole plugs removed from the right hand side to fill the holes
on the left.