Filter
Top Products
The DISPLAY
P~EL
telb
you if
certiin
things are wrong
DISPLAY
WHAT IT
ME~S
WHAT TO DO
l-/l-
Electrical power has been IF DISHWASHER WAS IN USE WHEN THE POWER
1-
/-
interrupted to the dishwasher but is
FAILURE OCCURRED:
now back on.
1. Unlatch the door.
Ifthedetergent
cupis
open, add
detergent and close the cup.
2.
Relatch
thedoorandtouch “START” then immediately
touch “CLEAR/RESET~’ (This will pump any remaining
water out of the machine. )
3. Select
thedesiredcycle
and rerun the load.
IF DISHWASHER WAS
N~IN
USE:
1. Latch door.
2. Select desired cycle.
3. Runcycle when desired.
-/
The dishwasher is taking longer This dishwasher is designed to automatically compensate for
~/
than normal to drain the water out. longer than normal drain times, but cycle time will be
This is usually caused by a blockage
extended. If this code continues to appear frequently then:
in the drain air gap (seepage 18), a
kink in the drain hose, or a stopped
1. Clean
theairgap
(seepage 18).
up drain pipe.
2. Check
forakinkin
the drain hose.
3. Check plumbing for slow or stopped up drains.
(N~E:
Warranty service does not cover household
drain problems.)
--
Similar to blocked drain as
Locate and remove the blockage in the drain system as
/
l-’
--
explained above, but the
[2
explained above. To pump any remaining water out of the
indicates that the drain is so
machine:
clogged that the dishwasher cannot
1. Latch door.
continue to operate in a satisfactory
manner. Dishwasher will stop.
2. Select any cycle.
3. Touch “START” andthen immediately touch “CLEAR/
RESET:’
(N~E:
Warranty service does not cover
household drain problems.)
--
-/
Dishwasher will not go into a drain
Restart the cycle. If
[3
repeats, call for service.
I
--
out period. Dishwasher will stop.
1- 1-/
There is too much water in the
The dishwasher is designed to automatically pump out extra
~
dishwasher. If
[9
appears aftera
water as long as the door is latched. When you hear the motor
power failure, this is normal and
stop running:
the dishwasher will correct itself.
1. Unlatch the door and see
ifall
the water is gone. (It is
normal for a small amount of water to remain in the bottom
of tub to keep the water seal lubricated.)
2. If you
seewater
entering the dishwasher, close and latch
the door. Shut off the water supply to the dishwasher.
3. If water is gone and no water is entering the dishwasher,
restart cycle.
4. If
[+
repeats, shutoff the water supply to the dishwasher.
Call for service.
8