Filter
Top Products
19
GB
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
COOKER FINISH CLEANING METHOD
Vitreous Enamel
Door inner panels, pan supports, burner caps,
roasting dish, grill pan, main oven base, inside of
grill compartment.
Hotplate
Cloth wrung out in warm soapy water. Stubborn stains can be
removed with a cream paste, liquid cleaner or by rubbing with fine
steel wool soap pads.
Check that the cleaning agent is approved by the Vitreous Enamel
Association.
Paint
Side panels.
Control panel, lid front trim
Wash with a cloth wrung out in warm soapy water only.
DO NOT USE ABRASIVES.
Aluminium
Hotplate burner bodies, lid rear trim.
Similar to paint cleaning above. Use a nylon brush to remove any
cleaning materials, water or dirt from the hotplate burner bodies.
Glass
As for enamel cleaning. Polish with a clean dry cloth or kitchen roll.
Chromium Plating
Oven shelves, grill pan grid, grill pan handle
support.
Wipe with a cloth wrung out in warm soapy water. A fine steel wool
soap pad e.g. Brillo, Ajax, or a chrome or stainless steel cleaner
may be used.
Plastic
Control knobs.
Wipe with a cloth wrung out in warm soapy water.
Stainless Steel
Hotplate, control panel ,grill pan handle,
Wipe with a cloth wrung out in warm soapy water. Polish with a
clean dry cloth or kitchen towel. For stubborn stains, use a
proprietary stainless steel cleaner and follow the instructions on the
container.
Care and Cleaning
Doors
Wipe over the outer door glass panels with a cloth
wrung out in warm soapy water, then after wiping
with a cloth wrung out in clear water, dry with a soft
clean cloth.
Ensure that glass doors are notEnsure that glass doors are not
Ensure that glass doors are notEnsure that glass doors are not
Ensure that glass doors are not
subjected to any sharp mechanical blows.subjected to any sharp mechanical blows.
subjected to any sharp mechanical blows.subjected to any sharp mechanical blows.
subjected to any sharp mechanical blows.
Glass Inner Door Panel (where fitted) Glass Inner Door Panel (where fitted)
Glass Inner Door Panel (where fitted) Glass Inner Door Panel (where fitted)
Glass Inner Door Panel (where fitted) –
open the door fully and
carefully slide the inner
glass towards you,
taking care not to allow
the glass to fall.
The glass panel may now be washed at the sink.
Stubborn stains can be removed by using a fine
steel wool soap pad.
Ensure the glass panel isEnsure the glass panel is
Ensure the glass panel isEnsure the glass panel is
Ensure the glass panel is
not subjected to any sharp mechanicalnot subjected to any sharp mechanical
not subjected to any sharp mechanicalnot subjected to any sharp mechanical
not subjected to any sharp mechanical
blows. blows.
blows. blows.
blows. Take particular care not to damage the inner
surface which is coated with a heat reflective layer.
After cleaning, rinse and dry with a soft cloth. For
slight soiling the inner glass panel may be cleaned,
while still warm, without removing it from the door.
Warning: Oven must not be operated with inner door
glass removed.
SIDE OPENING DOORS
Cleaning the door glass is the same as the drop
down doors, except take care to support the weight
of the inner glass when removing and refitting.
Take care Take care
Take care Take care
Take care during cleaning not to damage or distort
the door seals. Do not lift the door seal from the
oven chassis, if necessary remove the seal by
carefully unhooking the corner clips.
Take care Take care
Take care Take care
Take care that the rating label edges are not lifted
during cleaning, and furthermore that the lettering is
not blurred or removed.
When refitting the glass make sure it is fitted
correctly i.e. reflective face is fitted the right way
round.