Filter
Top Products
Before Fitting:
Before connecting to the electricity supply
leave the appliance to stand for 1 hour to
allow the cooling system to settle.
Please read through this section before
starting any work.
Choosing a location:
The power socket should be in a readily
accessible position,adjacent to the appliance.
Place the appliance in a dry and regularly
ventilated room.
Never place the appliance near heat emitting
devices (eg.cooker,radiator,water heater or
similar devices) and do not expose it to direct
sunlight. In such a position your appliance
will have to work harder and will cost more to
run and could be damaged by the heat.
Ensure that you provide adequate air
circulation around the appliance.
Behind,there should be at least 200cm
2
.
Allow a minimum 30mm between the top of
the appliance and the underside of the work
top, 25mm either side and 25mm from the
base of appliance to the floor.
Placing the appliance:
Place it on a solid base.
Use the adjustable feet to level the appliance.
Check using a spirit level and adjust the feet
accordingly.
Fitting the wall spacer
1. Fit the supplied wall spacer to the top
middle of the condenser at the back of
the appliance
2. Push appliance back,until spacer is
against the wall.
Installation.
WARNING:THE APPLIANCE SHOULD
ONLY BE INSTALLED BY A QUALIFIED
ELECTRICIAN IN COMPLIANCE WITH THESE
INSTRUCTIONS,CURRENT STANDARDS
AND REGULATIONS.
5