Filter
Top Products
11
GB
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
Switching the appliance off
Disconnect your appliance from the electricity supply
before carrying out any work on it.
Cleaning the appliance
• The stainless steel or enamel-coated external parts
and the rubber seals may be cleaned using a
sponge that has been soaked in lukewarm water
and neutral soap. Use specialised products for the
removal of stubborn stains. After cleaning, rinse and
dry thoroughly. Do not use abrasive powders or
corrosive substances.
• The inside of the oven should ideally be cleaned
after each use, while it is still lukewarm. Use hot
water and detergent, then rinse well and dry with a
soft cloth. Do not use abrasive products.
• All accessories can be washed like everyday
crockery, and are even dishwasher safe.
! Never use steam cleaners or pressure cleaners on
the appliance.
Cleaning the oven door
Clean the glass part of the oven door using a sponge
and a non-abrasive cleaning product, then dry
thoroughly with a soft cloth. Do not use rough abrasive
material or sharp metal scrapers as these could
scratch the surface and cause the glass to crack.
For more thorough cleaning purposes, the oven door
may be removed:
1. Open the oven door fully (
see diagram
).
2. Use a screwdriver to lift up and turn the small levers
F
located on the two hinges (
see diagram
).
3. Grip the door on the two
outer sides and close it
approximately half way. Pull the
door towards you, lifting it out
of its slot (
see diagram
). To
replace the door, reverse this
sequence.
Inspecting the seals
Check the door seals around the oven regularly. If the
seals are damaged, please contact your nearest
Service Centre (
see Assistance
). We recommend that
the oven is not used until the seals have been
replaced.
Replacing the light bulb
To replace the oven light bulb:
1. Remove the
glass cover of the
lamp-holder.
2. Unscrew the
light bulb and
replace it with a
similar one:
Wattage 25 W,
cap E 14.
3. Replace the
glass cover (
see
diagram
).
Side and rear catalytic liners*
These are panels coated with a special enamel, which
is able to absorb the fat released by food as it cooks.
This enamel is quite strong, so that the various
accessories (racks, dripping pans, etc.) can slide
along them without damaging them. White marks may
appear on the surfaces; these are not a cause for
concern.
Nevertheless, the following should be avoided:
- scraping the enamel with sharp objects (a knife, for
example);
- using detergents or abrasive materials.
Care and maintenance
*
Only available in certain models.
F