Filter
Top Products
10
Fast clean programming
The fast clean cycle time and/or cycle end time can be
programmed after selecting the fast clean mode.
Programming the fast clean cycle time
Press button 5 and then adjust the cycle time by turning
knob C. Press the OK button to store the setting. The time
left until the end of the fast clean cycle will be displayed.
Once this time is up, the word “end” will be displayed and
a sequence of acoustic signals will be sounded to indica-
te that the cleaning cycle is complete.
• Press any button to silence the acoustic signal.
• Turn knob B back to position 0 to remove the word
“end” from the display.
For example
It is 9:00 a.m. and a fast clean cycle time of 1 hour and
15 minutes is programmed. The fast clean cycle will end
automatically at 10:15 a.m..
Programming the fast clean cycle end time
Press button 4 and then adjust by turning knob C. Press
the OK button to store the setting. The time left until the
end of the fast clean cycle will be displayed.
When the fast clean cycle time previously selected is up,
the word “end” will be displayed and a sequence of acoustic
signals will be sounded to indicate that the fast clean cycle
is complete.
• Press any button to silence the acoustic signal.
• Turn knob B back to position 0 to remove the word
“end” from the display.
For example
It is 9:00 a.m. and the fast clean cycle end time is set at
10:15 a.m.. Fast clean will last 1 hour and 15 minutes.
Delayed fast clean cycle programming
Press button 5 and then adjust the cycle time by turning
knob C. Press the OK button to store the setting and
display it.
Press button 4 and then adjust the cycle end time by
turning knob C. Press the OK button to store the setting
and the display will remind you of the cycle end time and
of the actual cycle time set alternately.
For example
It is 9:00 a.m. and a fast clean cycle time of 1 hour and 15
minutes and 12:20 as the cycle end time are programmed.
The fast clean cycle will start automatically at 11:15 a.m..
The icon A will remind you that you have programmed the
fast clean cycle time and/or the cycle end time.
To cancel a programmed time
To cancel any programming you have made, set knob “B”
to position “0”.