Hotpoint SE1002X Oven User Manual


 
12
GB
Inspecting the seals
Check the door seals around the oven periodically. If
the seals are damaged, please contact your nearest
After-sales Service Centre (see Assistance). We
recommend not using the oven until the seals have
been replaced.
Replacing the light bulb
To replace the oven light bulb:
1. Remove the glass cover of the lamp-holder.
2. Remove the light bulb and replace it with a similar
one: halogen lamp voltage 230V, wattage 25 W, cap
G 9.
3. Replace the glass cover (see diagram).
! Do not touch the light bulb directly with your hands.
Warning:
The appliance is fitted with an automatic diagnostic
system which detects any malfunctions. Malfunctions
are displayed by messages of the type: ER followed
by numbers.
Call for technical assistance should a malfunction
occur.
Switching the appliance off
Disconnect your appliance from the electricity supply
before carrying out any work on it.
Cleaning the appliance
The stainless-steel or enamel-coated external parts
as well as the rubber seals may be cleaned using a
sponge that has been soaked in lukewarm water
and neutral soap. If these stains are difficult to
remove, use only specialised products. After
cleaning, rinse and dry thoroughly. Do not use
abrasive powders or corrosive substances.
Ideally, the inside of the oven should be cleaned
after each use, when it is still lukewarm. Use hot
water and detergent, rinse and dry with a soft cloth.
Do not use abrasive products.
The accessories can be washed like everyday
crockery (even in your dishwasher).
Cleaning the oven door
Clean the glass door using non-abrasive products and
sponges and dry it with a soft cloth.
To clean more thoroughly, you can remove the oven
door.
1. Open the oven door fully
(see diagram)
2. Lift up and turn the small
levers located on the two
hinges (see diagram)
3. Grip the door on the two
external sides and close it
approximately half way. Unlock
the door by pressing on the
clamps F, then pull the door
towards you lifting it out of its
seat (see diagram). To replace
the door, reverse this
sequence.
F
F
Maintenance and care