Filter
Top Products
GB
13
Automatic cleaning with the FAST
CLEAN function
With the FAST CLEAN mode, the internal temperature
of the oven reaches 500°C. The pyrolysis process is
activated and burns away food and grime residues.
During the automatic cleaning cycle, the surfaces may
become very hot. Keep children away from these.
Particles may ignite inside the oven due to the
spontaneous combustion process. Do not worry, this
process is both normal and hazard-free.
Before initiating the FAST CLEAN mode:
Remove large or course food residues from inside
of the oven using a damp sponge. Do not use
detergents.
Remove all accessories.
Do not place tea towels or pot holders over the
oven handle.
! If the oven is too hot, pyrolysis may not start. Wait for
the oven to cool down.
! The programme may only be started once the oven
door has been closed.
To enable the FAST CLEAN mode press
. Select
the desired FAST CLEAN mode level by adjusting +
and - on the right side of the control panel. The FAST
CLEAN mode has three default time settings which
cannot be modified:
1. Economy (ECO): 1 hour
2. Normal (NOR): 1 hour and 30 minutes
3. Intensive (INT): 2 hours.
Safety devices
The door is locked automatically as soon as the
temperature exceeds a certain value.
Should a malfunctoin occur, the heating elements
will switch off.
Once the oven door has been locked, you cannot
change the cycle time and end time settings.
! Programming is possible only after selecting the
FAST CLEAN mode.
Programme Delayed Cleaning
Press
, then:
1. Set the time using + and - on the left side of the
control panel.
2. Press
to store the setting.
3. Press START to activate programming.
4. When the selected time has elapsed, END appears
on the TEMPERATURE display and a buzzer sounds.
For example: it is 9:00 a.m. and the Economy (ECO)
FAST CLEAN mode level has been selected:
default set time 1 hour. 12:30 is selected as the end
time. The programme starts automatically at 11:30
a.m.
and blink, showing that programming has
been set. The CLOCK and COOKING TIME displays
show the FAST CLEAN end time and its duration
alternately.
To cancel programming press STOP.
Once the automatic cleaning cycle is over
You will have to wait until the temperature inside the
oven has cooled down sufficiently before you can
open the oven door. You will notice some white
dust deposits on the bottom and the sides of your
oven; remove these deposits with a damp sponge
once the oven has cooled down completely. You
may on the other hand prefer to take advantage of the
heat accumulated to start cooking immediately; in this
case the dust can stay where it is: it is completely
harmless and will not affect your food in any way.